1 applying policy to packets, Figure 352 menu 25.1.1: ip routing policy setup – ZyXEL Communications ZyXEL ZyWALL 35 User Manual
Page 552
ZyWALL 35 User’s Guide
550
Chapter 42 IP Policy Routing
42.2.1 Applying Policy to Packets
To apply the policy to packets received on the selected interface(s), go to Menu 25.1: IP
Routing Policy Setup and press [SPACE BAR] to select Yes in the Edit policy to packets
received from field. Press [ENTER] to display Menu 25.1.1 - IP Routing Policy Setup
(shown next).
Figure 352 Menu 25.1.1: IP Routing Policy Setup
port start / end
Source port number range from start to end; applicable only for TCP/UDP.
Destination
addr start / end
Destination IP address range from start to end.
port start / end
Destination port number range from start to end; applicable only for TCP/UDP.
Action
Specifies whether action should be taken on criteria Matched or Not Matched.
Gateway addr
Defines the outgoing gateway address. The gateway must be on the same subnet
as the ZYWALL if it is on the LAN, otherwise, the gateway must be the IP address
of a remote node. The default gateway is specified as 0.0.0.0.
Type of Service
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing Don't Care, Normal, Min Delay, Max Thruput, Max Reliable or Min
Cost.
Precedence
Set the new outgoing packet precedence value. Values are 0 to 7 or Don't Care.
Log
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
Edit policy to
packets received
from
Press [SPACE BAR] and then [ENTER] to select Yes or No (default). Select Yes to
configure Menu 25.1.1: IP Routing Policy Setup discussed next.
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous
screen.
Table 204 Menu 25.1: IP Routing Policy Setup
FIELD
DESCRIPTION
Menu 25.1.1 - IP Routing Policy Setup
Apply policy to packets received from:
LAN= No
DMZ= No
ALL WAN= Yes
Selected Remote Node index= N/A
Press ENTER to Confirm or ESC to Cancel: