2 ip routing policy setup, Table 203 ip routing policy setup – ZyXEL Communications ZyXEL ZyWALL 35 User Manual

Page 550

Advertising
background image

ZyWALL 35 User’s Guide

548

Chapter 42 IP Policy Routing

42.2 IP Routing Policy Setup

To setup a routing policy, perform the following procedures:

Criteria/Action

This displays the details about to which packets the policy applies and how the

policy has the ZyWALL handle those packets. Refer to

Table 203

for detailed

information.

Select Command

Press [SPACE BAR] to choose from None, Edit, Delete, Go To Rule, Next Page

or Previous Page and then press [ENTER]. You must select a rule in the next field

when you choose the Edit, Delete or Go To commands.
Select None and then press [ENTER] to go to the "Press ENTER to Confirm…"

prompt.
Use Edit to create or edit a rule. Use Delete to remove a rule. To edit or delete a

rule, first make sure you are on the correct page. When a rule is deleted,

subsequent rules do not move up in the page list.
Use Go To Rule to view the page where your desired rule is listed.
Select Next Page or Previous Page to view the next or previous page of rules

(respectively).

Select Rule

Type the policy index number you wish to edit or delete and then press [ENTER].

When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm…" to

save your configuration, or press [ESC] at any time to cancel.

Table 203 IP Routing Policy Setup

ABBREVIATION

MEANING

Criterion SA

Source IP Address

SP

Source Port

DA

Destination IP Address

DP

Destination Port

P

IP layer 4 protocol number (TCP=6, UDP=17…)

T

Type of service of incoming packet

PR

Precedence of incoming packet

Action GW

Gateway IP address

T

Outgoing Type of service

P

Outgoing Precedence

Service NM

Normal

MD

Minimum Delay

MT

Maximum Throughput

MR

Maximum Reliability

MC

Minimum Cost

Table 202 Menu 25: Sample IP Routing Policy Summary (continued)

FIELD

DESCRIPTION

Advertising