8 gui-based tftp clients, 9 backup via console port – ZyXEL Communications ZyXEL ZyWALL 35 User Manual

Page 526

Advertising
background image

ZyWALL 35 User’s Guide

524

Chapter 39 Firmware and Configuration File Maintenance

39.3.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Refer to

the File Maintenance Over WAN section

to read about configurations that disallow

TFTP and FTP over WAN.

39.3.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure shown
next. Procedures using other serial communications programs should be similar.

1 Display menu 24.5 and enter “y” at the following screen.

Figure 325 System Maintenance: Backup Configuration

2 The following screen indicates that the Xmodem download has started.

Figure 326 System Maintenance: Starting Xmodem Download Screen

3 Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the

following screen.

Table 196 General Commands for GUI-based TFTP Clients

COMMAND

DESCRIPTION

Host

Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP

address when shipped.

Send/Fetch

Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your

computer.

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration file

(*.rom extension) on your computer.

Remote File

This is the filename on the ZyWALL. The filename for the firmware is “ras” and for

the configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

Abort

Stop transfer of the file.

Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):

You can enter ctrl-x to terminate operation any
time.
Starting XMODEM download...

Advertising