ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 86)

ZyWALL 35 User’s Guide
84 Chapter 3 Wizard Setup
Figure 17 VPN Wizard : Gateway Setting
The following table describes the labels in this screen.
Table 16 VPN Wizard : Gateway Setting
LABEL DESCRIPTION
My IP Address Enter the WAN IP address of your ZyWALL or leave the field set to 0.0.0.0.
The following applies if the My IP Address field is configured as 0.0.0.0:
•
When the WAN port operation mode is set to Active/Passive, the ZyWALL uses
the IP address (static or dynamic) of the WAN port that is in use.
• When the WAN port operation mode is set to Active/Active, the ZyWALL uses the
IP address (static or dynamic) of the primary (highest priority) WAN port to set up
the VPN tunnel as long as the corresponding WAN1 or WAN2 connection is up. If
the corresponding WAN1 or WAN2 connection goes down, the ZyWALL uses the
IP address of the other WAN port.
• If both WAN connections go down, the ZyWALL uses the dial backup IP address
for the VPN tunnel when using dial backup or the LAN IP address when using
traffic redirect. See the chapter on WAN for details on dial backup and traffic
redirect.
The VPN tunnel has to be rebuilt if this IP address changes.
Secure
Gateway
Address
IP Address Select IP Address and enter the WAN IP address of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address.
Domain Name Select Domain Name and enter the domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by a domain name.
Next Click Next to continue.