1 outgoing authentication protocol, 2 nailed-up connection, 3 metric – ZyXEL Communications ZyXEL ZyWALL 35 User Manual
Page 462
ZyWALL 35 User’s Guide
460
Chapter 32 Remote Node Setup
Figure 264 Menu 11.1: Remote Node Profile for PPPoE Encapsulation
32.3.2.1 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for
obvious reasons. However, some vendor’s implementation includes a specific authentication
protocol in the user profile. It will disconnect if the negotiated protocol is different from that in
the user profile, even when the negotiated protocol is stronger than specified. If you encounter
a case where the peer disconnects right after a successful authentication, please make sure that
you specify the correct authentication protocol when connecting to such an implementation.
32.3.2.2 Nailed-Up Connection
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic
demand. The ZyWALL does two things when you specify a nailed-up connection. The first is
that idle timeout is disabled. The second is that the ZyWALL will try to bring up the
connection when turned on and whenever the connection is down. A nailed-up connection can
be very expensive for obvious reasons.
Do not specify a nailed-up connection unless your telephone company offers flat-rate service
or you need a constant connection and the cost is of no concern.
The following table describes the fields not already described in
32.3.2.3 Metric
See
the TCP/IP Priority (Metric) section
for details on the Metric
field.
Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe Route= IP
Active= Yes
Encapsulation= PPPoE Edit IP= No
Service Type= Standard Telco Option:
Service Name= Allocated Budget(min)= 0
Outgoing: Period(hr)= 0
My Login= Schedules=
My Password= ******** Nailed-Up Connection= No
Retype to Confirm= ********
Authen= CHAP/PAP
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 0
Press ENTER to Confirm or ESC to Cancel: