2 pppoe encapsulation – ZyXEL Communications ZyXEL ZyWALL 35 User Manual
Page 461
ZyWALL 35 User’s Guide
Chapter 32 Remote Node Setup
459
32.3.2 PPPoE Encapsulation
The ZyWALL supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use
PPPoE encapsulation when you’re using the ZyWALL with a DSL modem as the WAN
device. If you change the Encapsulation to PPPoE, then you will see the next screen. Please
see
for more information on PPPoE.
Retype to
Confirm
Type your password again to make sure that you have entered it correctly.
Server
This field is valid only when RoadRunner is selected in the Service Type field. The
ZyWALL will find the RoadRunner Server IP automatically if this field is left blank. If
it does not, then you must enter the authentication server IP address here.
Relogin Every
(min)
This field is available when you select Telia Login in the Service Type field.
The Telia server logs the ZyWALL out if the ZyWALL does not log in periodically.
Type the number of minutes from 1 to 59 (30 recommended) for the ZyWALL to wait
between logins.
Route
This field refers to the protocol that will be routed by your ZyWALL – IP is the only
option for the ZyWALL.
Edit IP
This field leads to a “hidden” menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.x.2 - Remote Node Network Layer Options.
Session Options
Edit Filter Sets
This field leads to another “hidden” menu. Use [SPACE BAR] to select Yes and
press [ENTER] to open menu 11.x.4 to edit the filter sets. See
for more details.
Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.
Table 173 Menu 11.1: Remote Node Profile for Ethernet Encapsulation (continued)
FIELD
DESCRIPTION