IntelliTrack Inventory Management - Manual (Page 181)

Chapter 12
Installing DMS CE Batch
155
Installing the CE Batch Portable Application
Once you complete the Batch installation prerequisites, including:
• Determining your Remote Data Access Setup;
• Installing IIS;
• Installing ActiveSync or Windows Device Center Software and estab-
lishing a partnership between your computer and your device;
• Installing the IntelliTrack workstation application and configuring IIS
dependencies;
• Setting the necessary firewall exceptions; please see “Applying Firewall
Exceptions” on page 31 for more information.
• Determining your Device Installation;
you are ready to install the DMS application to the handheld device.
Follow the instructions found in “Installing DMS CE Batch” on page 153 , to
install the Batch Portable application on the handheld device.
Reaching your Device Installation
Your device installation is downloaded from the Hardware Support Matrix
at the IntelliTrack website (
www.intellitrack.net ). For more information
about reaching installation setup please refer to the next sections: “Retriev-
ing your Device Installer from the Hardware Support Matrix” on page 156 .
Important: This section applies to DMS CE Batch; if you are using DMS
RF Batch this section does not apply to you. Before you install the applica-
tion to the device, make sure that you have set up your system for Remote
Data Access communication. Please refer to
“DMS CE Batch Setup” on
page 7 for more information about DMS Batch setup and RDA communi-
cation.
2287.book Page 155 Thursday, July 7, 2011 4:45 PM