IntelliTrack WMS – Warehouse Management System - Manual (Page 171)

Chapter 7
Inventory Management
145
Let Downs
To convert an item’s unit of measure to a lower unit of measure, you need
to perform a let down for the item’s quantity. (For more information about
units of measure, please refer to
“Unit of Measure” on page 65 . For more
information about defining an item’s units of measure, please refer to
“Establishing an Item Unit of Measure Range” on page 116 .)
Performing a
Let Down The let down is performed at the Inventory Let Down form. It is started by
clicking the Let Down button found along the bottom of the Inventory
Data, Move Item, Build Pallet, or Picking Order form:
Note: To perform a let down, the selected item must contain a quantity
that can be converted to a lower unit of measure. The units of measure
available for an item and the count for each unit of measure are set in the
Item Data form/Units of Measure tab.
• Inventory Data form: The Let Down button becomes enabled when
an item is selected.