LEESON SM4 Series Flux Vector - Manual (Page 46)

45
Commissioning
Code Possible Settings
IMPORTANT
No. Name Default Selection
P405 Current Network
Fault
0 No Fault
1 F.nF1
Netldle Mode
2 F.nF2 Loss of Ethernet I/O connection
3 F.nF3 Network Fault
4 F.nF4 Explicit Message Timeout
5 F.nF5 Overall Network Timeout
6 F.nF6 Overall Explicit Timeout
7 F.nF7 Overall I/O Message Timeout
P406 Proprietary Manufacturer specific
P407 … P499 Module Specific Parameters Refer to the Communications
Reference Guide specific to the
network or I/O module installed.
4.5.7 Diagnostic Parameters
Code
Display Range
(READ ONLY)
IMPORTANT
No. Name
P500 Fault History • Displays the last 8 faults
• Format: n.xxx
where: n = 1..8;
1 is the newest fault
xxx = fault message (without the F .)
• see Section 5.3
P501 Software version Format: x.yz
P502 Drive ID A flashing display indicates that the Drive ID
stored in the EPM does not match the drive
model it is plugged into.
P503 Internal Code Alternating Display: xxx-; -yy
P505 DC Bus Voltage 0 {VDC} 1500
P506 Motor Voltage 0 {VAC} 1000
P507 Load 0 {%} 255 Motor load as % of drive’s output current rating.
See section 2.2.
P508 Motor Current 0.0 {A} 1000 Actual motor current
P509 Torque 0 {%} 500 Torque as % of motor rated torque
(vector mode only)
P510 kW 0.00 {kW} 650.0
P511 kWh 0.0 {kWh} 9999999 Alternating display: xxx-; yyyy when value
exceeds 9999