LEESON SM4 Series Flux Vector - Manual (Page 49)

48
Commissioning
4.5.8 Onboard Communications Parameters 15-30HP (11-22kW)
The P6xx Onboard Communication parameters are applicable to the 15HP (11kW) and greater models only.
Code Possible Settings
IMPORTANT
No. Name Default Selection
P600 Network Enable 0 0 Disabled This parameter enables the onboard
network communications.
1 Remote Keypad
2 Modbus
7 Lecom
NOTE: Onboard Communications will be disabled if:
- P600 = 0, or
- P600 = 1 and P400 = 1, or
- P600 = 2 and P400 = 2, 3, 4, 5, 6 or 7
- P600 = 7 and P400 = 2, 3, 4, 5, 6 or 7
If the onboard communications are disabled, the user will not have
access to any of the other P6xx parameters.
P610
Network Address 1 1 - 247 Modbus
1 1 - 99 Lecom
P611 Network Baud Rate 2 0 2400 bps Modbus
1 4800 bps
2 9600 bps
3 19200 bps
0 0 9600 bps Lecom
1 4800 bps
2 2400 bps
3 1200 bps
4 19200 bps
P612 Network Data
Format
0 0 8, N, 2 Modbus Only
1 8, N, 1
2 8, E, 1
3 8, O, 1
P620
Network Control
Level
0 0 Monitor Only Lecom Only
1 Parameter Programming
2 Programming and Setpoint Control
3 Full Control
P624
Network Powerup
Start Status
0 0 Quick Stop Lecom Only
1 Controller Inhibit
P625 Network Timeout 10.0 0.0 - 300.0 seconds Modbus
50 0 - 65000 milliseconds Lecom