HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 103)

#3
This value depends on the trace file settings. The maximum is 1000 MB.
q = (t × n) ÷ 1024 (in MB),
where:
t is the size of the trace file (units: KB, default is 1,000), and
n is the number of trace files (default is 4). The resulting fraction will be
rounded up.
Number of LUs and Paths Supported in HDLM
The following table lists the number of LUs and paths supported in HDLM.
Table 3-19 Number of LUs and Paths Supported in HDLM
Item OS Supported number
Number of LUs Solaris 8, Solaris 9 1 to 256
Solaris 10, Solaris 11 1 to 4096 #
Number of physical
paths per LU
Solaris 8, Solaris 9, Solaris 10, Solaris
11
1 to 64
Total number of
physical paths
Solaris 8, Solaris 9 1 to 4096
Solaris 10, Solaris 11 1 to 8192 #
When Sun Cluster 3.1, Sun Cluster 3.2, or Oracle Solaris Cluster 3.3 is used,
configure a server so that the sum of the number of physical paths per an LU
for all nodes will be less than or equal to 15 as well as satisfying the
conditions shown in Table 3-19 Number of LUs and Paths Supported in HDLM
on page 3-37 .
#
For details on the supported configurations, see the Release Notes.
Flow for Creating an HDLM Environment
Set up the environment to use HDLM as follows.
• The installation procedure includes the Sun Cluster setup procedure.
• Execute the procedures described in Preparations for an Upgrade
Installation or Re-installation of HDLM on page 3-73 and Performing an
Upgrade Installation or Re-installation of HDLM on page 3-73 only when
upgrading or re-installing HDLM.
• Execute the procedures described in Creating File Systems for HDLM
(When Volume Management Software Is Not Used) on page 3-156 and
subsequent sections as required.
Creating an HDLM Environment
3-37
Hitachi Dynamic Link Manager (for Solaris) User Guide