HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 464)

Used) on page 3-55 , Performing a New Installation of HDLM (When Solaris
Cluster Is Being Used) on page 3-62 , or Performing an Upgrade Installation
or Re-installation of HDLM on page 3-73 .
If you use the -r or -t option when executing this utility, you need to
reconfigure the HDLM devices by using the dlmstart utility.
Format
/directory-where-DVD-ROM-is-mounted/HDLM_Solaris/installhdlm [ -f
installation-information-settings-file-name | -r | -t | -h]
Parameters
If you do not specify the -f or -h parameter, installation can be performed by
the pkgadd or pkg install command.
-f installation-settings-file-name
Defines the information required to perform an installation.
For details on the installation-information settings file, see
Contents of the
Installation-Information Settings File on page 7-34 .
-r
Executes the dlmstart utility to reconfigure the current HDLM
devices.
#1#2
-t
Executes the dlmstart utility and uses the existing HDLM driver
configuration definition file (dlmfdrv.conf) to reconfigure the HDLM
devices.
#1
-h
Displays help about the usage of the command.
#1
This can be used with Solaris 10 or Solaris 11 only.
#2
When HDLM version 8.0.0 or later is installed from HDLM 7.6.0 or earlier,
command execution results in an error. If this occurs, do the following to
reconfigure the HDLM devices:
¢
Execute the following dlmsetconf utility:
# /opt/DynamicLinkManager/bin/dlmsetconf
¢
Restart the host.
Contents of the Installation-Information Settings File
The following describes the contents of the installation-information settings
file.
7-34
Utility Reference
Hitachi Dynamic Link Manager (for Solaris) User Guide