Allied Telesis AT-DC2552XS - Manual (Page 168)

Chapter 7: Event Log Commands
168 Section I: Switch Management
NO LOG
Syntax
no log buffered|permanent|console|host ipv4_address
Parameters
buffered
Stops logging event messages in the buffered log in RAM on the
switch. By default, the switch stores event messages in the
buffered log.
permanent
Stops logging event messages in the permanent log in Flash
memory on the switch. By default, the switch stores event
messages in the permanent.
console
Stops sending event messages defined as the console log to the
Console port. By default, the switch sends these event messages
to the Console port.
host
Stops sending event messages to a syslog server that you specify
by its IPv4 address.
ipv4_address
Specifies the IPv4 address of the syslog server.
Mode
Global Configuration mode
Description
Use this command to instruct the switch to stop sending event messages
to the specified destination.
Confirmation Command
“SHOW LOG CONFIG” on page 172