Allied Telesis AT-DC2552XS - Manual (Page 260)

Chapter 11: Port Parameter Commands
260 Section II: Layer 2 Switching
SHOW INTERFACE
Syntax
show interface [ port_ids |sa X |po X |eth0]
Parameters
port_ids
Specifies a port ID or multiple port IDs. Use a comma (,) to
separate port IDs and a hyphen (-) to indicate a range of port IDs.
sa X
Specifies a static port trunk ID or multiple static port trunk IDs
where X indicates the number of the port trunk ID. Use a comma (,)
to separate port IDs and a hyphen (-) to indicate a range of port
IDs.
po X
Specifies a dynamic port trunk ID or multiple dynamic port trunk
IDs where X indicates the number of the port trunk ID. Use a
comma (,) to separate port IDs and a hyphen (-) to indicate a range
of port IDs.
eth0
Specifies the management Ethernet port.
Modes
Privileged Exec mode
Description
Use this command to display information about the ports. When you do
not specify a port interface, the switch displays information about all the
switch ports and the management port. See Figure 45 on page 261 for an
example of the information.