Allied Telesis AT-DC2552XS - Manual (Page 484)

Chapter 21: Quality of Service (QoS) Commands
484 Section V: Security and Traffic Control
You must enable QoS on the switch to use this command. To enable QoS,
see “MLS QOS ENABLE” on page 503.
To delete a class map, use the NO CLASS-MAP command.
Confirmation Command
“SHOW CLASS-MAP” on page 513
Examples
To create a class-map called “cmap1” and access the Configuration
Class-map mode, do the following:
awplus> enable
awplus# configure terminal
awplus(config)# class-map cmap1
awplus(config-cmap)#
To delete a class-map called “cmap1,” do the following:
awplus> enable
awplus# configure terminal
awplus(config)# no class-map cmap1