Allied Telesis AT-DC2552XS - Manual (Page 59)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section I: Switch Management 59
SERVICE TERMINAL-LENGTH
Syntax
service maxmanager length
Parameter
length
Specifies the maximum number of lines that the SHOW commands
display on the screen at once. The range is 0 to 512 lines. Use the
value 0 if you do not want the SHOW commands to pause. The
default value is 20 lines.
Mode
Global Configuration mode
Description
Use this command to specify the maximum number of lines that the
SHOW commands display on the screen at once.
If the maximum number of lines is set by the TERMINAL LENGTH
command, the switch uses that setting to displays output. Here is the
priority of the commands, listing the highest priority command first:
1. The TERMINAL LENGTH command
2. The SERVICE TERMINAL-LENGTH command
3. The LENGTH command
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Example
This example sets the maximum number of lines to 30:
awplus> enable
awplus# configure terminal
awplus(config)# service terminal-length 30