Allied Telesis AT-DC2552XS - Manual (Page 438)

Chapter 19: IGMP Snooping Commands
438 Section IV: IPv4 Multicast
The fields are described in Table 73.
Table 73. SHOW IP IGMP SNOOPING Command
Field Description
IGMP Snooping Configuration:
IGMP Snooping Status Displays the status of IGMP snooping on
the switch. The options are:
 Enabled
 Disabled
To enable IGMP snooping, refer to See “IP
IGMP SNOOPING” on page 429.
Host Topology Displays the IGMP host node topology on
the switch specified by the IP IGMP
STATUS command. The options are:
 Single-Host - Each port has only one
host.
 Multi-Hosts - Each port can have more
than one host node.
To set the IGMP host node topology, refer
to See “IP IGMP STATUS” on page 431.
Host/Router Timeout
Interval Displays the amount of time the switch
uses to time out inactive host nodes and
multicast routers. To set this parameter,
refer to “IP IGMP QUERIER-TIMEOUT” on
page 428.
Maximum IGMP Multicast
Groups Displays the maximum number of multicast
groups the switch supports. This number is
specified by the IP IGMP LIMIT command.
Refer to “IP IGMP LIMIT” on page 427.
Router Port(s) Displays the ports connected to multicast
routers. If you do not manually assign
multicast router ports using the IP IGMP
SNOOPING MROUTER INTERFACE
command, this field displays “Auto Detect.”
Refer to “IP IGMP SNOOPING MROUTER
INTERFACE” on page 430.
Router List:
VLAN ID Displays the ID number of the VLAN of the
router ports.