Allied Telesis AT-DC2552XS - Manual (Page 175)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section I: Switch Management 175
SHOW LOG PERMANENT
Syntax
show log permanent [tail [ value ]]
Parameters
tail
Displays the newest event messages in the permanent log that
reside in Flash memory. When no value parameter is specified, the
command displays 20 messages.
value
Specifies the number of the newest event messages to display.
The range is 10 to 250 messages. By default, this value is 20.
Mode
Privileged Exec mode
Description
Use this command to display the messages in the permanent log stored in
the Flash memory of the switch. To cancel the display, type ‘q’ for quit.
See Figure 34 for an example of the command output.
Figure 34. SHOW LOG Permanent Command
The fields in the log are described below:
<date> <time> <facility>.<severity> <program[<pid>]>: <message>
-------------------------------------------------------------------------
2011 Oct 22 14:39:04 user.error awplus system: Fan3 Status fault
2011 Oct 26 11:15:02 user.error awplus enco: key file a.cfg to node failed[565]
2011 Nov 15 13:40:11 user.warning awplus rmon: RMON falling threshold reached
2011 Nov 15 14:55:04 user.error awplus vlan: VLAN Creation failed[236]
2011 Nov 15 14:55:45 user.error awplus vlan: VLAN Creation failed[236]
Table 26. SHOW LOG Permanent Command
Field Description
Date Indicates the date the message was entered in the
permanent log.
Time Indicates the time the message was entered in the
permanent log.