Allied Telesis AT-DC2552XS - Manual (Page 242)

Chapter 11: Port Parameter Commands
242 Section II: Layer 2 Switching
CUT-THROUGH
Syntax
cut-through
Parameters
None
Mode
Port Interface mode
Description
Use this command to change the switch forwarding method to cut-through
switching on a port or ports. Two switch forwarding methods are available
on each port: cut-through switching and store-and-forward switching. By
default, all the ports are set with the store-and-forward switching method.
Use the NO CUT-THROUGH command to configure ports with the store-
and-forward switching method.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Examples
This example changes the switch forwarding method to cut-through
switching:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.20
awplus(config-if)# cut-through
This example changes the switching forwarding method to store-and
forward switching:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.20
awplus(config-if)# no cut-through