Allied Telesis AT-DC2552XS - Manual (Page 413)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section III: IPv4 Management 413
SHOW IP ROUTE
Syntax
show ip route
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the IP routing table on the switch. See
Figure 66 for an example of the command output.
Figure 66. SHOW IP ROUTE Command
The fields are described in Table 69.
-------------------------------------------------------------------
Destination
Mask NextHop Interface Protocol
-------------------------------------------------------------------
192.168.1.0
255.255.255.0 192.168.1.1 eth0 INTERFACE
192.168.10.0 255.255.255.0 192.168.10.1 vlan1-0 INTERFACE
0.0.0.0 0.0.0.0 192.168.1.32 eth0 STATIC
Table 69. SHOW IP ROUTE Command
Field Description
Destination Displays the network address of the destination.
Mask Displays the subnet mask of the destination
network address.
NextHop Displays the next hop address.
Interface The VID of the VLAN to which the management IP
address is assigned.