No channel-group – Allied Telesis AT-DC2552XS User Manual
Page 285
AT-DC2552SX Switch Command Line Interface User’s Guide
285
NO CHANNEL-GROUP
Syntax
no channel-group
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove ports from an LACP trunk group and to
delete the LACP trunk group. To delete an LACP trunk group, remove all
the member ports.
You cannot remove the base port of the LACP trunk group. If you want to
change the base port, you must delete and recreate the LACP trunk group.
Confirmation Command
“SHOW ETHERCHANNEL” on page 288
Example
This example deletes ports 1.0.11 and 1.0.12 from an LACP trunk group.
The LACP trunk group is deleted if ports 1.0.11 and 1.0.12 are the only
member ports of the trunk group:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11-port1.0.12
awplus(config-if)# no channel-group