Allied Telesis AT-DC2552XS - Manual (Page 202)

Chapter 8: SNMP Commands
202 Section I: Switch Management
SNMP-SERVER CONTACT
Syntax
snmp-server contact contact
Parameter
contact
Specifies a system administrator’s contact information. The
maximum length is 255 alphanumeric characters. This parameter
is case-sensitive. Special characters are permitted with the
exception of exclamation marks (!) and question marks (?).
Mode
Global Configuration mode
Description
Use this command to set the value of the MIB object sysContact.
Confirmation Command
“SHOW SYSTEM” on page 119
Example
This example sets the value of the MIB object sysContact to
“[email protected]”:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server contact [email protected]