Allied Telesis AT-DC2552XS - Manual (Page 266)

Chapter 11: Port Parameter Commands
266 Section II: Layer 2 Switching
The fields are described in Table 43.
Examples
This command displays the settings of all the ports:
awplus# show interface status
This command displays the settings of port 1.0.17, port 1.0.18, and the
management port:
awplus# show interface port1.0.17,1.0.18 status
Table 43. SHOW INTERFACE STATUS Command
Field Description
Port Displays the port ID.
Name Displays the description of the port. To set the
description, refer to “DESCRIPTION” on page 243.
Status Displays the link status of the port. The options are:
 connected: link up
 not connect: link down
 disabled: shutdown
VLAN Displays the ID of the VLAN when the port is an
untagged member. If the port is a tagged port,
“trunk” is displayed.
Duplex Displays the duplex mode. When the port status is
“connected,” the switch displays the current duplex
mode of the port. The prefix “a-” means that the
duplex mode is set with Auto-negotiation. When the
port status is “not connect” or “disabled,” the switch
displays the duplex mode setting of the port.
Speed Displays the speed. When the port status is
“connected,” the switch displays the current speed
of the port. The prefix “a-” means that the speed is
set with Auto-negotiation. When the port status is
“not connect” or “disabled,” the switch displays the
speed setting of the port.
Type Displays the media type of the module connected
to the port interface. When SFP+ and QSFP+ ports
do not recognize the module, the switch displays
“Unknown.” When no module is connected or the
connected module is not working, the switch
displays “not present.”