Allied Telesis AT-DC2552XS - Manual (Page 261)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 261
Figure 45. SHOW INTERFACE Command
The fields are described in Table 41.
Interface port1.0.1
Link is UP, administrative state is UP
Address is 0014.7700.0001
Description:
index 1 mtu 12288
current duplex full, current speed 10G, polarity auto, flowcontrol disabled
configured duplex full, configured speed 10000
Unknown Ingress Multicast Blocking: Disabled
Unknown Egress Multicast Blocking: Disabled
SNMP link-status traps: Disabled (Suppressed in 0 sec.)
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 15, bytes 2880, multicast packets 45 broadcast packets 0
Interface port1.0.2
Link is UP, administrative state is UP
Address is 0014.7700.0002
Description:
index 2 mtu 12288
current duplex full, current speed 10G, polarity auto, flowcontrol disabled
configured duplex full, configured speed 10000
Unknown Ingress Multicast Blocking: Disabled
Unknown Egress Multicast Blocking: Disabled
SNMP link-status traps: Disabled (Suppressed in 0 sec.)
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 55, bytes 3520, multicast packets 55broadcast packets 0
Table 41. SHOW INTERFACE Command
Field Description
Interface Indicates the port number.
Link is Indicates the link status of the port.
administrative state
is Indicates the administrative state of the port. The
administrative state is DOWN if the port was
disabled with the SHUTDOWN command.
Address is Displays the MAC address of the port.
Description Displays the port’s description. To set the
description, refer to “DESCRIPTION” on
page 243.
Index Displays the index number of the port. This field
is only for the switch ports.