Allied Telesis AT-DC2552XS - Manual (Page 236)

Chapter 10: NTP Client Commands
236 Section I: Switch Management
SHOW NTP STATUS
Syntax
show ntp status
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to determine whether or not the switch has
synchronized its time with the specified NTP server. See Figure 43 for an
example of the information.
Figure 43. SHOW NTP STATUS Command
The information is described here:
Example
This example displays information about an NTP server:
awplus# show ntp status
Table 38. SHOW NTP ASSOCIATIONS Command
Field Description
Clock is Indicates if the time on the switch is synchronized or
unsynchronized with the NTP server.
Reference Displays the IP address of the NTP server. This
value is set with “NTP PEER” on page 232.
clock offset Displays the specified time difference, in hours and
minutes, between UTC and local time. This value is
set with “CLOCK TIMEZONE” on page 230.
Clock is synchronized, reference is 172.17.28.1
Clock offset is -07:00