Allied Telesis AT-DC2552XS - Manual (Page 412)

Chapter 17: IPv4 Management Address Commands
412 Section III: IPv4 Management
SHOW IP INTERFACE
Syntax
show ip interface
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the management IPv4 address on the
switch. See Figure 65 for an example of the information.
Figure 65. SHOW IP INTERFACE Command
The fields are described in Table 68.
Example
This example displays the management IPv4 address on the switch:
awplus# show ip interface
Table 68. SHOW IP INTERFACE Command
Field Description
Interface Displays the name of the interface to which the
management IP address is assigned. A VLAN
interface is displayed with the “-0” suffix.
IP Address Displays the IPv4 management address and
subnet.
Status Displays the management status of the interface as
up or down.
Protocol Displays the link status of the interface as running or
down.
Interface IP-Address Status Protocol
eth0 192.168.1.1/24 admin up running
VLAN1-0 192.168.10.1/24 admin up down