Allied Telesis AT-DC2552XS - Manual (Page 258)

Chapter 11: Port Parameter Commands
258 Section II: Layer 2 Switching
SHOW FLOWCONTROL INTERFACE
Syntax
show flowcontrol interface port_ids
Parameter
port_ids
Specifies a port ID or multiple port IDs. Use a comma (,) to
separate port IDs and a hyphen (-) to indicate a range of port IDs.
Modes
Privileged Exec mode
Description
Use this command to display the current settings for flow control on the
ports. The switch supports flow control to suspend packets from
forwarding when receiving PAUSE packets and does not support flow
control to transmit PAUSE packets. See Figure 44 for an example of the
information.
Figure 44. SHOW FLOWCONTROL INTERFACE Command
The fields are described in Table 40.
Table 40. SHOW FLOWCONTROL INTERFACE Command
Parameter Description
Port Indicates the port ID.
Send admin Not supported.
Receive admin Indicates flow control is enabled (yes) or
disabled (no).
RxPause Indicates the number of received PAUSE
packets.
TxPause Not supported.
Port Send Receive RxPause TxPause
admin admin
----- ------- ------- ------- -------
1.0.13 no yes 0 0