Allied Telesis AT-DC2552XS - Manual (Page 369)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 369
SPANNING-TREE MAX-HOPS
Syntax
spanning-tree max-hops maxage
Parameter
maxage
Specifies the maximum number of hops. The range is 1 to 40 hops.
The default is 20 hops.
Mode
Global Configuration mode
Description
Use this command to set the maximum number of hops that BPDUs can
be forwarded to.
Note
This command is applicable only when MSTP is enabled.
To restore the default 20 hops, use the NO SPANNING-TREE MAX-
HOPS command.
Confirmation Command
“SHOW SPANNING-TREE” on page 344
Example
This example sets the maximum number of hops to 40 hops:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree max-hops 40