Lenze E94AYCEP - Manual (Page 34)

6 Commissioning
6.1 Before initial switch-on
35
Lenze · E94AYCEP communication module (POWERLINK MN/CN) · Communication Manual · DMS 6.0 EN · 02/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Commissioning
During commissioning, plant-specific data such as motor parameters, operating parameters,
responses, and parameters for fieldbus communication are defined for the inverter. Lenze devices
use codes for this purpose.
The codes of the inverter and for communication are saved to the memory module in a non-volatile
data set.
In addition, there are codes for diagnosing and monitoring the stations.
6.1 Before initial switch-on

Note!
When parameterising the communication module, please note that the code number
depends on the slot of the Servo Drive 9400 into which the communication module is
plugged.
The first two digits of the code number indicate the slot:
• C13nnn for slot MXI1
 Parameters of the communication module for slot MXI1 ( 71)
• C14nnn for slot MXI2
 Parameters of the communication module for slot MXI2 ( 101)
You also have to set the Parameters of the standard device that are relevant to
communication ( 69) .

Stop!
Before switching on the Servo Drive 9400 and the communication module for the first
time, check the entire wiring for completeness, short circuit and earth fault.