Lenze E94AYCEP - Manual (Page 90)

11 Parameter reference
11.2 Parameters of the communication module for slot MXI1
91
Lenze · E94AYCEP communication module (POWERLINK MN/CN) · Communication Manual · DMS 6.0 EN · 02/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C13226
C13228
Parameter | Name:
C13226 | EPL node status MN
Data type: UNSIGNED_8
Index: 11349 = 0x2C55
EPL index: See subcodes
The code indicates the current NMT statuses of the Managing Node.
Each subcode corresponds to an EPL node with node ID = subcode number. The EPL node must be enabled via
C13029 .
Selection list Info
0 Off NMT_GS_OFF
25 Initialising NMT_GS_INITIALISING
41 ResetAppl NMT_GS_RESET_APPLICATION
57 ResetComm NMT_GS_RESET_COMMUNICATION
121 ResetConfig NMT_GS_RESET_CONFIGURATION
28 NotActive NMT_MS_NOT_ACTIVE
29 PreOp1 NMT_MS_PRE_OPERATIONAL_1
93 PreOp2 NMT_MS_PRE_OPERATIONAL_2
109 ReadyToOp NMT_MS_READY_TO_OPERATE
253 Operational NMT_MS_OPERATIONAL
77 Stopped Only for Controlled Node
30 BasicEthernet Only for Controlled Node
Subcodes Info EPL index
C13226/1 Managing Node 0x1F8E.0xF0
C13226/2 Diagnostics device 0x1F8E.0xFD
C13226/3 router 0x1F8E.0xFE
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13228 | EPL time-out isochronous comm.
Data type: UNSIGNED_32
Index: 11347 = 0x2C53
EPL index: See subcodes
The code defines Controlled Node-specific timeout times to answer the PReq request frames by PRes response
frames. Each subcode corresponds to an EPL node with node ID = subcode number.
Setting range
(min. value | unit | max. value)
0 ns 4294967295
Subcodes Lenze setting Info EPL index
C13228/1 5000 ns Managing Node 0x1F92.0xF0
C13228/2 5000 ns Diagnostics device 0x1F92.0xFD
C13228/3 5000 ns router 0x1F92.0xFE
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT