Lenze DDS System bus CAN for PLC - Manual (Page 86)

System bus (CAN) for Lenze PLC devices
Configuration (CAN−AUX interface)
6−12
l
PLC−Systembus EN 2.0
6.11.2 Telegram counter
Via C2460 you can have the number of the telegrams sent and received by the PLC via
CANaux1_IO ... CANaux3_IO.
·
Only the telegrams which are valid for the PLC are counted.
·
Each transmit and receive channel is evaluated separately.
·
The max. counter content is 65535 (16 bit); if this value is exceeded, the corresponding
counter starts with 0 again.
Code LCD Possible settings Information
Lenze Selection
C2460 CAN message g 0 {1} 65535 System bus telegram counter
(number of telegrams)
·
For values > 65535 counting
restarts with 0.
1 Message OUT All sent
2 Message IN All received
3 Message OUT1 Sent on CANaux_OUT1
4 Message OUT2 Sent on CANaux_OUT2
5 Message OUT3 Sent on CANaux_OUT3
6 Message POUT1 Sent on parameter data channel 1
7 Message POUT2 Sent on parameter data channel 2
8 Message IN1 Received from CANaux_IN1
9 Message IN2 Received from CANaux_IN2
10 Message IN3 Received from CANaux_IN3
11 Message PIN1 Received from parameter data
channel 1
12 Message PIN2 Received from parameter data
channel 2