Rockwell Automation 1791ES-IB16 Guard I/O EtherNet/IP Safety Modules - Manual (Page 35)

Rockwell Automation Publication 1791ES-UM001D-EN-P - May 2013 35
Install and Connect Your Modules Chapter 3
Use DIN rail that is 35 mm (1.38 in.) wide to install the module in the control
panel. See the figure that shows required spacing.
Figure 14 - Required Spacing
Connect the Ethernet Cable See the Ethernet Design Considerations Reference Manual, publication
ENET-RM002 , for information about Ethernet cable.
Set Network (IP) Address The module ships with the rotary switches set to 999 and DHCP enabled.
Wi
rin
g D
uc
t
15 mm
(0
.6 in.) Min
35 mm (1.38 in.) DIN Rail
Use horizontal or
vertical mounting.
End Plate
Wi
rin
g D
uc
t
15 mm (0.6 in.
) Min
44407
End Plate