Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual - Manual (Page 191)

Rockwell Automation Publication 1783-UM004E-EN-P - June 2014 191
Manage the Switch via the Studio 5000 Environment Chapter 5
• Configuration data (requires password)
– IP address method: DHCP, static
– IP address, subnet mask, default gateway (all if static)
– Host name
– Contact name
– Geographic location
– Port configuration per port: enable/disable, autonegotiate, forced
speed/duplex
– Authorized MAC ID per port
– Unicast rate limiting threshold per port: in packets per second, bits per
second, or percentage
– Multicast rate limiting threshold: in packets per second, bits per sec, or
percentage
– Broadcast rate limiting threshold: in packets per second, bits per sec, or
percentage
• Smartport assignment per port: role and VLAN
• Save and restore of switch configuration (via File Obj)
Add a Switch to the I/O
Configuration Tree To add the switch to the controller’s I/O tree, follow these steps.
1. Open the project file for the controller that monitors the switch.
2. Select the Ethernet module through which the controller communicates
with the switch.
In this example, the switch communicates through a 1769-L32E
CompactLogix EtherNet/IP controller.
3. Right-click the Ethernet port you created and choose New Module.
4. Click Communications.
IMPORTANT These steps are required before you can go online to configure and monitor the
switch.