Armorstratix 5700 switch installation, Installation guidelines – Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual User Manual

Page 57

Advertising
background image

Rockwell Automation Publication 1783-UM004E-EN-P - June 2014

57

Switch Installation Chapter 2

ArmorStratix 5700 Switch
Installation

Installation Guidelines

ATTENTION: Environment and Enclosure

This equipment is intended for use in overvoltage Category II applications (as

defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.

This equipment is not intended for use in residential environments and may not

provide adequate protection to radio communication services in such
environments.

This equipment is supplied as enclosed equipment. It should not require additional

system enclosure when used in locations consistent with the enclosure type ratings
stated in the Specifications section of this publication. Subsequent sections of this
publication may contain additional information regarding specific enclosure type
ratings, beyond what this product provides, that are required to comply with
certain product safety certifications.

In addition to this publication, see the following:

Industrial Automation Wiring and Grounding Guidelines, publication

1770-4.1

,

for additional installation requirements

NEMA Standard 250 and IEC 60529, as applicable, for explanations of the

degrees of protection provided by enclosures

ATTENTION: Prevent Electrostatic Discharge

This equipment is sensitive to electrostatic discharge, which can cause internal

damage and affect normal operation. Follow these guidelines when you handle
this equipment:

Do not touch connectors or pins on component boards.
Do not touch circuit components inside the equipment.

ATTENTION: Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP enclosure type
requirements.

ATTENTION: The console ports are intended for temporary local programming
purposes only and not intended for permanent connection.

The console port cables are not to exceed 3.0 m (9.84 ft) and must not contain

hubs.

Advertising