Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual - Manual (Page 43)

Rockwell Automation Publication 1783-UM004E-EN-P - June 2014 43
Switch Installation Chapter 2
8. Connect the other end of the positive wire to the positive terminal on the
DC power source, and connect the other end of the return wire to the
return terminal on the DC power source.
When you are testing the switch, one power connection is sufficient. If you
are installing the switch and are using a second power source, repeat this
procedure with the second power connector.
The following figure shows the completed DC input wiring on a power
connector for a primary power source and an optional secondary power
source.
Attach the Switch Power Connectors
To attach the switch power connectors to the front panel of the switch, follow
these steps.
1. Insert one power connector into the Pwr A receptacle on the switch front
panel, and the other into the Pwr B receptacle.
32282-M
Pwr A Receptacle
Pwr B Receptacle
32283-M