Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual - Manual (Page 59)

Rockwell Automation Publication 1783-UM004E-EN-P - June 2014 59
Switch Installation Chapter 2
Install or Remove the SD Card (optional)
The switch supports a Secure Digital (SD) memory card to store firmware and
the startup configuration. This storage makes it possible to replace a switch
without reconfiguring the replacement switch.
The SD memory card cover protects the card against shock and vibration by
holding the card in place. The cover is hinged and secured with captive screws.
The slot for the SD memory card is located on the side of the switch.
To install or replace the SD card, follow these steps.
1. On the side of the switch, loosen the captive screws until they are free.
2. Install or remove the card:
• To install the card, slide it into the slot, and press on it until it clicks in
place. The card is keyed so that you cannot insert it the wrong way.
• To remove the card, push it in until it releases for it to pop out. Place it
in an antistatic bag to protect it from static discharge.
3. Close the guard door and fasten the captive screws to 1.8…2.2N•m
(15.93…19.47 lb •in) to maintain IP67 compliance.
380394