Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual - Manual (Page 42)

42 Rockwell Automation Publication 1783-UM004E-EN-P - June 2014
Chapter 2 Switch Installation
6. Insert the exposed part of the positive wire into the connection labeled
DC+ and the exposed part of the return wire into the connection labeled
DC-.
Be sure that you cannot see any wire lead. Only wire with insulation can
extend from the connector.
7. Use a ratcheting-torque screwdriver to torque the power connector captive
screws (above the installed wire leads) to 0.23 N•m (2.0 lb•in).
Do not exceed the recommended torque.
ATTENTION: An exposed wire lead from a DC-input power source can
conduct harmful levels of electricity. Be sure that no exposed portion of
the DC-input power source wire extends from the connector(s) or
terminal blocks.
32279-M
32281-M