Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual - Manual (Page 44)

44 Rockwell Automation Publication 1783-UM004E-EN-P - June 2014
Chapter 2 Switch Installation
2. Use a ratcheting torque flathead screwdriver to tighten the captive screws
on the sides of the power connectors.
When you are testing the switch, one power source is sufficient. If you are
installing the switch and are using a second power source, repeat this
procedure for the second power connector (Pwr B), which installs just
below the primary power connector (Pwr A).
3. When you are installing the switch, secure the wires coming from the
power connectors to the rack by using tie wraps.
Wire the Power over Ethernet DC Power Source
This procedure applies only to switches with PoE ports.
The switch must be wired and grounded.
WARNING: The console port is intended only for temporary local programming
purposes and not intended for permanent connection. If you connect or
disconnect the console cable with power applied to this module or the
programming device on the other end of the cable, an electrical arc can occur.
This could cause an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
ATTENTION: To comply with the CE Low Voltage Directive (LVD), this
equipment must be powered from a source compliant with the safety extra low
voltage (SELV) or protected extra low voltage (PELV).
To comply with UL restrictions, this equipment must be powered from a source
compliant with Class 2 or Limited Voltage/Current.
32284-M