Rockwell Automation 1783-BMxxx Stratix 5700 Ethernet Managed Switches User Manual - Manual (Page 61)

Rockwell Automation Publication 1783-UM004E-EN-P - June 2014 61
Switch Installation Chapter 2
Mount the Switch
To mount the switch, follow these steps.
1. Position the rear panel of the switch against the wall or a panel in the
desired location.
2. Place a number-10 screw that you provide through each mounting ear, and
screw them into the wall.
ATTENTION: To prevent bodily injury when mounting or servicing this unit in a
rack, you must take special precautions to ensure that the system remains
stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the
rack.
• When mounting this unit in a partially filled rack, load the rack from the
bottom to the top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
32477