Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 110)

Chapter 3 Collecting Performance Data
The Lookup Code Configuration dialog box appears.
To configure an Event Value Reason Code lookup list:
1. In the Lookup Code Description box, type a name for the
Event Value Reason Code lookup list.
2. Under Lookup Code Values, click Add.
The Lookup Code Value dialog box appears.
3. In the Value box, type a value.
4. In the Description box, type a description of the value.
5. Under Severity Level, select either of the following:
• Do not record a Severity Level for this Lookup Code
Value
This is the default setting.
• Specify a Severity Level for this Lookup Code Value
Type a value between 0 (high severity) and 100 (low
severity) that will be used to determine how serious the
event is when this lookup code value is collected.
6. Select any of the following:
7. Click OK.
The value appears under Lookup Code Values.
Instead of manually configuring a lookup code list, you can import
an existing list from a comma-separated values file (.csv).
NOTE
If a Shift Description lookup list already contains values, you and intend
to import other values to this list, the original values will be replaced
with the new ones.
110 Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014