Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 214)

Chapter 6 Customizing RSBizWare Charts and Tables
NOTE
When you make modifications to a report object, all instances of the
report object (such as those on other RSBizWare reports) will reflect the
changes you have made.
Charts typically consist of three components: a title at the top, a
chart in the middle, and a legend at the bottom. The default layout is
fine for most charts, however, you can also change the layout of your
chart if needed. Perhaps the legend would fit better in another place
on the chart, or the legend should be resized because it is too small to
show all of the legend keys.
A chart component must be in edit mode in order to be modified.
To set a chart component in edit mode:
1. Make sure your RSBizWare report is in design mode.
2. Click the chart.
The edit mode on the chart is enabled, and the component will
have eight resizing handles and a highlighted border,
indicating that it is ready to be modified.
3. Click the individual chart components and put them in edit
mode.
Working With the
Component Parts of a Chart
214 Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014