Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 136)

Chapter 3 Collecting Performance Data
When you click: These values are displayed:
Event The user-defined events that occurred during the specified
period of time for the selected activity area.
In this table, you can type reason codes and comments for
each user-defined event.
OEE The OEE and other performance values calculated from the
values collected during a specified period of time for the
selected activity area.
In this table, you cannot edit any records.
Schedule The shift-related time values that were collected during the
specified period of time for the selected activity area.
In this table, you can modify the scheduled available and
actual available values for the activity area.
Scrap The scrap events that occurred during the specified period
of time for the selected activity area.
In this table, you can type comments for the scrap event. If
the scrap event has a lookup list associated with it, you may
also type a reason code for the scrap event.
3. Click Schedule.
In the right pane of the dialog box, a set of toolbars and a table
appear.
The time selection toolbar (marked with the red frame in the
figure above) controls the time period for which the data will
be displayed in the table. By default, the past two hours are
displayed. If you want to modify a record that was collected
more than two hours ago, use the tools on the toolbar to
change the time period:
136 Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014