Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 167)

Automated Configuration Chapter 4
9. In the FTTM configuration list, select the name of the
FactoryTalk Transaction Manager configuration that you
want to use.
10. In the Event categories box, type the location of or click
to navigate to the location of a CSV file with control
connector values and event categories assigned to them, which
you want to add to the configuration.
11. (FTM UDT configuration only) Select the Disable events
check box, if you do not want the information on the
occurrence of the events for the selected workcells to be
collected in the database.
By default, all events for the selected workcells are registered,
and the information on their occurrence is collected in the
database.
If you want to enable this option again after you import the
configuration to FactoryTalk Metrics, you need to do this in
the Configuration Console.
12. Click Generate FT Metrics XML.
The following message appears:
13. Click Import to FT Metrics.
The configuration is imported to FactoryTalk Metrics.
If the configuration was imported with errors, a message listing
the number and code of the errors appears.
Check the error log file for details, correct the configuration,
and then try again.
Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014 167