Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 33)

Collecting Performance Data Chapter 3
11. Under Time Spans, right-click the area and then click New
Time Span.
The Time Span dialog box appears.
12. Make sure that the value type is set to State and the value is set
to Available.
13. Set the start time of the shift to
0:00
, and the end time to
4:00
.
NOTE
Since the shift times are relative, the start time in this example means
“the start time of the shift”, and the end time means “4 hours into the
shift time”.
14. Click OK.
The new time span appears under Time Spans.
15. Repeat steps 11-14, and create another time span with the start
time set to
4:30
, and the end time set to
8:00
.
Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014 33