Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 147)

Automated Configuration Chapter 4
The shortcut will reference all data tags within a given
ControlLogix device. If the device contains data tags from only
one workcell, it is recommended that you give the same name
to both the workcell that you created for the FactoryTalk
Metrics UDT in your plant model and the shortcut. If the
device contains data tags from more than one workcell, use
some other meaningful name for the shortcut. Create a
shortcut for each ControlLogix device.
12. On the Primary tab, navigate to the controller to which you
are creating the shortcut.
13. Click the controller, and then click Apply.
The following message appears:
14. Click Yes.
15. At the bottom of the window, click Verify.
Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014 147