Rockwell Automation FactoryTalk Metrics User Guide - Manual (Page 152)

Chapter 4 Automated Configuration
4. Next to the Data Type box, click .
The Select Data Type dialog box appears.
5. Under Data Types, click FTM_Workcell.
6. In the Dim 0 box, change the value to the number of workcells
in your controller.
7. Click OK.
In this example, we created an array of 6 workcells.
8. Click Create.
The array of UDT instances appears at the bottom of the list
of the controller tags. The tags are named Workcell[0],
Workcell[1], etc. These instances are sufficient to configure
the same number of FactoryTalk Metrics workcells.
152 Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014