Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 200)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
182
3. Click inside the display where you want to start drawing the first point
of the polygon (point "a" in the example below).
4. Drag to create the first side (point "a" to point "b" in the example
below).
5. Release the mouse button to position the second point of the polygon
(point "b" in the example below).
6. Click at each of the remaining points of the polygon (points "c"
through "g" in example below). Lines are drawn between the clicks.
7. To close and fill the polygon, double-click to place the last point in the
polygon (point "g" in the example below). This action draws a line
from the last point to the first point (point "g" to point "a" in the
example below).
Polyline Symbol
A Polyline is a set of line segments that you can draw using the Polyline
tool. It uses the current line style attributes.
Once you add a Polyline symbol, you may edit it in the same manner as the
existing Polygon symbol. You can move or resize the entire symbol, as
well as move the individual endpoints to create any desired arrangement.