Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 235)

6
●
Work with Symbols
●
●
●
●
●
217
The Flow tab shows two tree diagrams, Source and Destination, where you
can change the Connection Points for the Connector shown in the
Connector drop-down box. There is also a Flow Direction drop-down box
associated with the Connector that appears in the Connector drop-down
box.
Each Connector and each Connection Point are numbered.
Use the ToolTip on the display to identify the Connector(s) and Connection
Point(s) you wish to rearrange before you open the Connectors dialog box.
The Auto Avoid option is checked as a default, so that Connectors route
around other objects in the display.