Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 234)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
216
If you are using a symbol from the Symbol Library, the Connection Point
is named <TBSymbolx : n>, where TBSymbolx represents the specific
name of the symbol.
Connectors Dialog Box
In Build mode, if you wish to adjust a Connector's end point, you might
click and drag the end point. Unfortunately, this action stops the auto-
avoidance capability of the Connector.
Alternatively, you can use the Connectors dialog box to rearrange
connections. To reach this dialog box:
Click the Connectors toolbar button,
-or-
Click Edit > Connectivity,
-or-
On the right-click menu, click Connectivity.
The Connectors dialog box affects Connector symbols only. It cannot be
used to attach one symbol to another symbol without a Connector. The
Connectors dialog box has two tabs, Flow (page 216) and Attachments
(page 219). Each Connector is identified by a unique number, which is
revealed by a ToolTip in your display.
Connectors Dialog Box, Flow Tab
The Connectors dialog box, Flow tab specifies the source and destination
of each Connector from one symbol's Connection Point to another symbol's
Connection Point. The dialog box is available whenever a Connector exists
on a display.