Rockwell Automation FactoryTalk Historian SE ProcessBook 3.2 User Guide - Manual (Page 220)

●
●
●
●
●
FactoryTalk Historian ProcessBook User Guide
202
In Run mode, click View > Revert, or click the Revert button.
Change the Time Range
The Time Range command lets you enter new starting and ending times
for dynamic symbols. When you specify a time range for a single-time
dynamic element, such as a Multi-State symbol, bar or value, only the end
time is used.
The time represented on your display is the time relative to the FactoryTalk
Historian server, unless you have selected the client time zone setting for your
display. If the FactoryTalk Historian server to which you are connected is in a
different time zone, time on your display represents the server time zone, not the
local one.
To change the time range:
1. In Run mode, select the dynamic symbol or symbols for which you
want to change the time range. If no symbols are selected, the time
range change affects all dynamic symbols on the display.
2. Click on the Time Range toolbar, or click View > Time Range.
The Change Time Range dialog box opens, allowing you to change
the time span for a trend or plot, or the effective time for a bar, value,
or Multi-State symbol.